Icom MR-1220 Series Instruction Manual page 27

using an Alarm function
D Entering the Power Save mode
While the Alarm function is active, you can turn off
the display while waiting for an alarm, to conserve the
battery power.
z Hold down [tX (SAVE)]/[
while the Alarm 1 and/or 2 function is on.
• the radar enters Power Save mode, and the display
turns off.
When a target comes into the Guard zone, an alarm
sounds, and the display turns on, and the Power
Save mode is canceled.
Push [tX (SAVE)]/[
Power Save mode.
NOTE: if the alarm icon is "
function is invalid because the invalid screen
range is selected. in that case, push [+]/[–] until
the alarm icon returns to "
] for 1 second
] to manually cancel the
", the alarm
."
D Setting the Zone alarm type
You can select the alarm type in the menu screen.
Select "Zone Alarm 1" or "Zone Alarm 2" in the
System menu.
Zone Alarm 1 / 2
] > System > Zone Alarm 1
[mEnu]/[
] > System > Zone Alarm 2
[mEnu]/[
Selects the Alarm type.
• Enter: An alarm sounds when a target comes into
the zone.
• Exit: An alarm sounds when the target goes out of
the zone.
4
AlArm function
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22