Table of Contents
Advertisement
Step 3:
Insert the cable
with the USB connectors on the PCIE-9452, connect the cable connectors to the
onboard connectors. See Figure 5-18.
Figure 5-18: Dual USB Cable Connection
Step 4:
Attach the bracket to the chassis. The USB 2.0 connectors are attached to a
bracket. To secure the bracket to the chassis please refer to the installation
instructions that came with the
5.6.8 SATA Drive Connection
The PCIE-9452 is shipped with two SATA drive cables and one SATA drive power cable.
To connect the SATA drives to the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See Figure 5-19.
Page 102
PCIE-9452 PICMG 1.3 CPU Card
connectors.
Once the cable connectors are properly aligned
chassis.Step 0:
Advertisement
Table of Contents
