Table of Contents
Advertisement
PCIE-9452 PICMG 1.3 CPU Card
Figure 5-17: Dual RS-232 Cable Installation
Step 3:
Secure the bracket. The dual RS-232 connector has two D-sub 9 male
connectors secured on a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the
5.6.7 USB Cable (Dual Port)
The PCIE-9452 is shipped with a dual port USB 2.0 cable. To connect the USB cable
connector, please follow the steps below.
Step 1:
Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2:
Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the PCIE-9452 USB connector.
chassisStep 0:
Page 101
Advertisement
Table of Contents
