General Characteristic Data; Module Selection - Bosch Control 8313 Service Instructions For Contractors

Menu structure
9.1

General characteristic data

Submenu Settings/
adjustment
range
Language
Date format
Calendar
Time
Time Zone Europe/Berlin
Europe/London
Europe/Paris
Europe/Moscow
Universal time/
Greenwich Mean
Time
Minimum outdoor –30...–10...0 °C The minimum outside temperature is the average
temperature
Building Light
Medium
Heavy
Insulation standard Small
Medium
Good
Outside temperature source ZM
Control unit 00
External heat demand None
Off/On
Temperature
Output
Table 6 General characteristic data menu
9.2

Module selection

When the control unit is switched on or after a reset, the modules are
automatically recognised and their information downloaded.
If the modules are not recognised automatically:
▶ Set the modules manually.
Submenu
Slot A
Slot 1...4
Table 7 Module selection menu
18
Explanation
Selection of language of texts displayed.
Selection of date format
Entry of date
Entry of time
of coldest outside temperature recorded in each
previous year.
Poor heat storage capability, e.g. pre-fabricated
houses, wooden-framed constructions
medium heat storage capability,
e.g. house built with hollow blocks
High thermal storage capacity,
e.g. house made of bricks
No or minimum insulation effect, e.g. house
without insulation
Medium insulating effect, e.g. house with 10 cm
mineral wool
Large insulating effect, e.g. new build or
renovated house with 20 cm mineral wool
The outside temperature sensor is connected to
this control unit.
The outside temperature sensor is connected to a
different control unit. The sensor values are
transmitted via the BUS.
WA1/3 closed = external heat demand on
Specifies the effect the 0...10 V input (WA1/2) is
to have on the system.
Specifies the effect the 0...10 V input (WA1/2) is
to have on the system.
Settings/adjustment range
ZM5313
None
Module selection
Note
Regional zone where the same time applies
▶ For regional average minimum outside
temperature values, refer to tab. 23
( Chapter 10.1, page 30).
▶ Adapt heating system to the construction
( Chapter 10.2.1, page 30).
▶ Adapt heating system to the insulation
situation ( Chapter 10.2.2, page 30).
The parameter is only displayed with control
units with address > 0 (e.g. substations).
 Chapter 10.3.1, page 31
 Chapter 10.3.2, page 31
Explanation
Automatic recognition and
installation of the modules for slot A
The installed modules can be
selected from a list.
Note
Slot for boiler module
Slots for function modules and
auxiliary modules
Control 8313 – 6720859567 (2017/03)