Information On The Reset Main Menu; Information On The Version Main Menu; Information On The Connectivity Main Menu; Establishing A Network With Other Control 8000 Control Units - Bosch Control 8313 Service Instructions For Contractors

14

Information on the reset main menu

All default values in the main menu and in the service menus can be
restored with the Reset menu.
Once the reset has been confirmed with Reset, this can no longer be
cancelled!
Once maintenance is completed, the service displays must be reset.
The maintenance interval is restarted when the service displays are
reset.
When the service display is set according to date, the next maintenance
date will be scheduled for one year in the future.
Resets Explanation
Settings All adjustable values in the operating menu or service
Control unit menu are reset to the default settings.
Exception: The time program is retained.
Operating Hours The hours run by the burner and the number of
- Burner 1 burner starts are set to 0.
Fault history All faults saved in the fault history are deleted.
Service display This reset will only be shown if a service display was
activated. This reset deletes the service display.
This restarts the maintenance interval.
Table 26 Available resets
Example of fault history Reset
The Fault history function resets all fault displays. This function deletes
all entries in the fault history.
▶ Call up Service menu ( Chapter 6.8, page 14).
▶ Tap Reset.
▶ In the dropdown list under Fault history, tap Reset.
The prompt Do you want to restore factory settings? appears.
▶ Tap Cancel field.
The dropdown list is displayed again. The reset is aborted.
-or-
▶ Tap Reset field.
The prompt Please note! This procedure will cause all settings on
all components of the control system to be lost. Do you want
continue? appears.
▶ Tap Continue field.
All existing entries are deleted.
Control 8313 – 6720859567 (2017/03)
15

Information on the Version main menu

You can check the software versions of the user interface and the control
unit via the Version menu.
The MAC address, time zone and Open Source information are also
displayed here.
Open Source information
You can find Open Source information on the DVD supplied with the
device.
16

Information on the Connectivity main menu

This function can be used to link control units, connect the control
unit(s) to the Internet or establish a network. To establish the
connection, a data cable must be connected to connections 9 to 11 of
the user interface ( Fig. 13, page 16).
16.1 Establishing a network with other Control 8000
control units
A connection can be established between control units via the LAN1
(input) and LAN2 (output) interfaces. To do this, the control units must
be inter-connected using a LAN cable. With heat source cascades, this
must be done via a FM-CM function module.

16.1.1 Establishing a network

The connection between control units must be established via a LAN
cable.
1 2
LAN1 LAN2 LAN1 LAN2
CBC-BUS
4
Fig. 22 Control unit connection
[1] Control unit 83xx address 0 (Master)
[2] Control unit 83xx address 1 (Slave)
[3] Control unit 83xx address 2 (Slave)
[4] Heat source
Lead boiler (Master)
The lead boiler (Master) has the control unit address 0.
▶ Insert LAN cable in the LAN2 connection ( Fig. 13, [10], page 16).
▶ Set the address switch ( Fig. 13, [5], page 16) to 0.
Information on the reset main menu
3
LAN1 LAN2
CBC-BUS CBC-BUS
0010010538-001
37