Calling Up The Service Menu; Function Keys Of The User Interface; Reset Key; Chimney Sweep Button (Flue Gas Test) - Bosch Control 8313 Service Instructions For Contractors

Hide thumbs Also See for Control 8313:
Table of Contents

Advertisement

Function keys of the user interface

6.8

Calling up the service menu

The Service menu is protected against unauthorised use. The Service
menu is intended exclusively for approved heating contractors.
Unauthorised access will invalidate the warranty!
The Service menu can only be accessed from the system overview.
To call up the Service menu:
▶ Tap
and hold for roughly 5 seconds.
1
Fig. 9
Call up Service menu
[1]
Fault history, Service display
In the Service menu tap the symbol
symbol
to select the Monitor data.
1
2
Fig. 10 Service menu
[1]
Symbols for available functions
[2]
Monitor data
14
12:00
0010009028-001
to select the Settings or the
12:00
0010008706-001
7
Function keys of the user interface
4
3
2
Fig. 11 Function buttons
[1]
Reset button
[2]
Chimney sweep button
[3]
Manual operation key
[4]
LED status display
7.1

Reset key

When the key is pressed
the locking fault is unlocked and the
functions are reset (e.g. following triggering of the high limit safety cut-
out or resetting of the SAFe).
To unlock a function:
▶ Key
Hold down for 2 seconds.
7.2

Chimney sweep button (flue gas test)

WARNING:
Risk of scalding from hot water!
Setting the set temperature > 60 °C creates a risk of scalding.
▶ Do not draw off DHW unmixed.
To perform the flue gas test:
▶ Observe the relevant national requirements for limiting flue losses
from the heating system.
The flue gas test is switched on if required at the heat source
( Technical documentation of heat source) or at the control unit.
▶ Ensure heat consumption within the heating system.
▶ Starting from the initial position, hold the key
seconds.
The flue gas test starts immediately.
The parameters for defining the conditions under which the flue gas
test is carried out are shown in the display.
▶ Setting parameters (e.g. modulation).
▶ Tap Save.
The heat source is operated at the set output.
Control 8313 – 6720859567 (2017/03)
1
0010007084-001
down for several

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents