Operating The Appliance; Modifying Settings; Labelling A Text Field; Labelling The Text Field Of The Fm-Si Module (Accessory) - Bosch Control 8313 Service Instructions For Contractors

6.4

Operating the appliance

The operating instructions contain information on operation of the
control unit.
▶ Observe the operating instructions of the control unit.
A description of operation of the control unit from the contractor's
standpoint is provided below.
6.5

Modifying settings

1
°C
7 8 9 C
4 5 6 +
-
1 2 3
.
x
0
OK
Off
6
Fig. 7 Modifying settings
[1] Numerical values
[2] Selection box
[3] Scale
[4] Cancel
[5] Off/On
[6] Save
Changes to parameters can be made in a number of different ways,
depending on the menu item.
• Changing numerical value
Numerical values can be changed by entering the number directly.
A keyboard opens when you tap the numerical field.
▶ Type in numerical values and
If the values you entered are invalid, the previous value will be
displayed.
• Scale
You can change the value by tapping the Plus and Minus keys.
• Selection box
Tap this field to open a selection box. Tap on the required parameter/
function to select it.
• Label text field ( Chapter 6.6, page 13)
• Off/On
Tap on the required parameter/function to select it.
To save the changes:
▶ Tap Save field.
To cancel the operation:
▶ Tap Cancel field.
If parameters are linked to settings, a temperature, for example, can only
be selected/modified if the function is set to On.
Fields that are not active are highlighted in grey.
Control 8313 – 6720859567 (2017/03)
2 3
-30 -22 -15 -7
On
5 4
0010007715-001
.
6.6

Labelling a text field

In some cases, the selection box contains an empty field/User-defined
which can be labelled by entering text.
▶ Tap on the empty field.
A keyboard opens.
▶ Enter a suitable text for the length of the field.
▶ Confirm entry with
To save the changes:
▶ Tap Save field.
To cancel the operation:
▶ Tap Cancel field.
0
6.7 Labelling the text field of the FM-SI module
(accessory)
You can name the inputs of the FM-SI safety module according to the
connected safety equipment.
If other devices are connected, you can assign your own names to these
by entering text in an empty field. If fields have been selected but not
saved, the selection is reset.
To label a field:
▶ Tap the field.
The pre-selection opens.
▶ Select name.
-or-
▶ Tap FM-SI field.
A keyboard opens.
▶ Enter a suitable text for the length of the field and tap
To save the change:
▶ Tap Save field.
To cancel the operation:
▶ Tap Cancel field.
1
Fig. 8 Labelling a text field
[1] FM-SI1
[2] Name of safety equipment
[3] Free
[4] Allocated
[5] Cancel
Save
[6]
Operation of the control unit
2 3
6 5
to apply.
4
0010009240-001
13