Installation; Assembly; Overview Of Controller; Electrical Connection - Bosch Control 8313 Service Instructions For Contractors

Installation

5 Installation
5.1

Assembly

Descriptions of how the control unit is positioned at the heat source are
provided in the installation instructions for the control unit and
documentation for the heat source.
5.2

Overview of controller

12
11
10
9
Fig. 3 Overview of controller
[1] Housing lid/cover
[2] User interface
[3] Touch screen
[4] Reset button (e.g. high limit safety cut-out, SAFe)
[5] Chimney sweep button (Flue gas test)
[6] Key for manual operation
[7] Cover (USB interface for service purposes, behind cover)
[8] LED status display
[9] Type plate
[10] F1-, F2 circuit breaker
[11] ON/OFF switch
[12] Back panel
8
1 2 3
8 7 6 5 4
5.3

Electrical connection

NOTICE:
Faults/material damage due to inductive interference!
▶ Make sure all low-voltage cables are routed separately to mains
voltage cables (min. clearance 100 mm).
WARNING:
Risk to life and of system damage due to high temperatures.
All parts directly or indirectly exposed to high temperatures must be
designed to withstand these temperatures.
▶ Keep cables and electrical wiring at a safe distance from hot
components.
▶ Route cables and electrical wiring in the cable routings provided,
or above the insulation.
NOTICE:
Material damage as a result of disregarding other instructions!
If other instructions for components are disregarded, the heating system
may develop faults or be damaged due to incorrect connections/settings.
▶ Follow the directions in all instructions for the components that are to
be installed.
Control 8313 – 6720859567 (2017/03)
1
0010003622-001