Malaguti Dune X 125 Service Station Manual page 99

Dune 125 - Dune X 125 - Euro 4
Electrical specifications

Clutch engaged: closed circuit (con-
tinuity)

Clutch released: open circuit (infinite
resistance)
Pin-out
1. 12 V Voltage (brown/white)
2. Ground (blue/green)
Diagnostic tool - Parameters and statuses

Clutch - (Pulled, Released)
Diagnosis
Even with the clutch lever engaged, the vehicle does not start
Error cause

Possible malfunction
Troubleshooting

Verify that, if a gear is engaged, the stand is up.

If it is up, check continuity of the brown/white cable and control unit PIN 18.

If there is no continuity, restore the wiring harness.

If there is continuity, disconnect the sensor and, with the clutch engaged, check for continuity
between the two sensor PINs.

If absent, replace the sensor.

If present, check for continuity of the blue/green cable between the sensor and control unit
PIN 15.

If absent, restore the wiring harness.
The vehicle starts even without pulling the clutch lever
Error cause

Possible malfunction
Troubleshooting

Disconnect the terminals from the sensor and check that, with the clutch released, there is
continuity between the two PINs.

If there is continuity, replace the sensor.

If there is no continuity, this means that the blue/green cable which goes from the sensor
PIN 2 to the control unit PIN 15 is shorted to ground.
Electrical system
ELE SYS - 99