Dune 125 - Dune X 125 - Euro 4
Rear braking system
Unscrew and remove the screws (5) on
the rear braking circuit fluid tank (6).
Lift and remove the cover (7)
Lift and remove the Teflon lid (8) and
the gasket (9).
Top up the tank (6) with the recom-
mended brake fluid until the sight glass
is completely covered.
CAUTION
ONLY FILL TO THE "MAX" LEVEL AFTER FITTING NEW
BRAKE PADS. DO NOT FILL TO THE "MAX" LEVEL WITH
WORN PADS, AS THIS WILL CAUSE FLUID TO ESCAPE
WHEN REPLACING BRAKE PADS.
CHECK BRAKING EFFICIENCY.
IF THE DEAD ZONE OF THE BRAKE PEDAL OR BRAKE
LEVER IS TOO LONG, OR IN CASE OF FLUID LOSS, IT
MAY BE NECESSARY TO BLEED THE AIR TRAPPED IN
THE SYSTEM.
Adjusting the levers
NOTE
NO ADJUSTMENT IS POSSIBLE FOR THE FRONT BRAKE LEVER.
SEE THE CHAPTER "INSTALLING THE REAR BRAKE MASTER CYLINDER" FOR THE PROCE-
DURE FOR ADJUSTING THE REAR BRAKE LEVER.
Clutch system
Maintenance
MAIN - 57