Table of Contents
Advertisement
Chassis
0.6 mm (0.0236 in)
Maximum lateral (B) eccentricity:
0.5 mm (0.0197 in)
CROWN GEAR
Check the condition of the teeth of the crown gear (3).
If excessively worn:
replace the crown gear.
TO PREVENT NEW COMPONENTS FROM WEARING PREMATURELY, THE REAR SPROCKET,
FRONT SPROCKET AND DRIVE CHAIN MUST ALWAYS BE REPLACED TOGETHER AS A SET.
CAUTION
WHEN REPLACING THE SPROCKET REPLACE THE PRE-IMPREGNATED SCREWS WITH NEW
ONES. BEFORE FITTING THE SCREWS CAREFULLY CLEAN THE THREADED HOLES REMOV-
ING ANY RESIDUES.
Installing
Repeat the removal procedure in re-
verse order, taking care to insert the
spacer correctly on the left hand side,
as indicated in figure.
Tighten the nuts, applying the
predetermined torque
CAUTION
AFTER MOUNTING THE REAR WHEEL, CHECK THAT THE DISTANCE BETWEEN THE
SPEER SENSOR AND THE PHONIC WHEEL IS BETWEEN 0.3 mm (0.012 in) AND 2 mm
(0.079 in).
CHAS - 204
Dune 125 - Dune X 125 - Euro 4
.
Advertisement
Table of Contents
