Dune 125 - Dune X 125 - Euro 4
Rear Brake Pad Removal
Loosen the brake pad pins [A ]
Remove the rear caliper with the brake hose installed
(see rear Caliper Removal).
Remove: Pad Pin Jaw Side Pad [A] Piston Side Pad [B ]
Rear Brake Pad Installation
Push the caliper piston in by hand as far as it will go.
Install the anti-rattle spring in its correct position.
Install the pad on the piston side first, then install the other pad.
Tighten the brake pad pins temporary.
Install the rear brake caliper (see Caliper Installation).
Tighten:
Torque - Rear Caliper Brake Pad Pins: 17 N· m (1.7 kgf · m, 13 ft· Ib)
WARNING
DO NOT ATTEMPT TO DRIVE THE MOTOCYCLE UNTIL A FULL BRAKE LEVER IS OBTAINED BY PUMPING
THE BRAKE LEVER UNTIL THE PADS ARE AGAINST THE DISC. THE BRAKE WILL NOT FUNCTION ON THE
FIRST APPLICATION OF THE LEVER IF THIS IS NOT DONE.
Brake Pad Wear Inspection
Refer to the Brake Pad Wear Inspection in the Periodic Maintenance chapter.
Braking system
BRAK SYS - 229