HP StorageWorks Modular Smart Array 1000 cs User Manual page 36

Using the CLI
Basic command
Command options
Locating all drives attached to the MSA
To flash the LEDs of all drives attached to the MSA:
Example command
Locating all drives in a specific storage enclosure
To flash the LEDs of all drives in the MSA drive shelf or additional storage
enclosures:
Example command
36
LOCATE
—(optional) the length of time to flash the LEDs, where xxx
TIME=xxx
represents the number of seconds.
—all drives connected to the MSA storage sub-system will be flashed.
ALL
—the number of the storage enclosure whose disks you want to flash.
BOX
1=the MSA drive shelf
2=the storage enclosure attached to SCSI port A
3=the storage enclosure attached to SCSI port B
—the number of the bus whose disks you want to flash.
BUS
—the number of the LUN whose disks you want to flash.
UNIT
—a range of drives to flash. Disks are identified by box
DISKxxx-DISKyyy
number and bay number.
—a specific drive to flash. Disks are identified by box number and
DISKzzz
bay number.
CLI> LOCATE ALL
CLI> LOCATE BOX 3
—the drives in the storage enclosure attached to SCSI port B will be
BOX 3
flashed.
Modular Smart Array 1000/1500 cs Command Line Interface User Guide