Setting Hard Addressing; Changing The Cli Prompt - HP StorageWorks Modular Smart Array 1000 cs User Manual

Using the CLI

Setting hard addressing

To enable or disable Fibre Channel Arbitrated Loop hard addressing on an MSA
controller:
Basic command
Example command
Command options
Example CLI response

Changing the CLI prompt

To temporarily change the CLI prompt from the default of "
Basic command
Example command
Command options
Example CLI response
34
SET THIS_CONTROLLER_HARD_ADDRESS
CLI> SET THIS_CONTROLLER_HARD_ADDRESS ENABLE 1
—enables hard addressing on the controller.
ENABLE
—disables hard addressing on the controller.
DISABLE
—a decimal number between 0 and 125 to assign the loop identifier.
1
CLI> SET THIS_CONTROLLER_HARD_ADDRESS ENABLE 1
Hard Addressing is enabled.
Loop ID = 1, ALPA = 0xE8
SET PROMPT
CLI> SET PROMPT ABC
—the user-defined name for the prompt. The name can be up to 24
ABC
alphanumeric characters. In this example, the prompt will be changed to
ABC.
ABC>
Modular Smart Array 1000/1500 cs Command Line Interface User Guide
":
CLI>