Lun Management Commands; Flashing Leds/Locating Hard Drives - HP StorageWorks Modular Smart Array 1000 cs User Manual

LUN management commands

The following commands are used to physically locate the specific hard drives in a
LUN as well as create, delete, and modify storage LUNs.

Flashing LEDs/locating hard drives

A variety of commands are available for physically locating specific hard drives.
Specifically, you can locate all drives attached to the MSA, all drives in a specific
storage enclosure, all drives on a specific SCSI bus, all drives in a specific LUN,
or a specific individual hard drive.
When these commands are executed, the LEDs of the requested drives will blink.
These LEDs are visible from the front of the MSA and its attached storage
enclosures.
Note:
seconds.
The basic command verb is
command options are available to customize the request.
Modular Smart Array 1000/1500 cs Command Line Interface User Guide
Flashing LEDs/locating hard drives
Creating LUNs
Assigning a name or ID to a LUN
Adding a spare to a LUN
Deleting LUNs
Deleting spares
Recognizing a failed unit
Modifying arrays and LUNs
If a time limit is not included with the Locate command, the LEDs will blink for 30
, but a variety of command nouns and
LOCATE
Using the CLI
35