Installing The Base - Britax Safe'n'Sound Instructions For Installation & Use

INSTALL INTO VEHICLE
Remove all packaging from the Baby Capsule.
Consult the car owner's handbook for location of top tether anchorage points.
If there is no child restraint anchor fitting or child restraint anchor point refer to pages 49
to 53 for the installation of the anchor fitting as well as the use of extension straps.
An anchor fitting is required to attach the top tether strap to fully install the Capsule to
the car. The top tether strap must be used with this Baby Capsule when used in the car.
For installing the Base to the car, select a seating position with a child restraint anchor
fitting directly behind the seating position.
ADJUSTING THE BASE ANGLE
A. Place the base and Baby Capsule on vehicle seat
in a seating position where a child restraint anchor
fitting is installed. The Level Indicator Line should
be level with the road, (i.e. parallel with the road
surface). Check and adjust the Levelling knob of
the base if necessary.
B. If your car's seat is contoured then you may need
to adjust the angle of the base so your baby is not
too upright.
The angle may be altered by turning the base
levelling knob located at the rebound bar end
which will cause the levelling foot to extend from
the underside of the base.

INSTALLING THE BASE

Instructions for Installation & Use
Level Indicator Line on
both sides of base.
Levelling Knob
21