Suitable For Use - Britax Safe'n'Sound Instructions For Installation & Use

SUITABLE FOR USE

570mm
If the baby's neck muscles are unable to support
their head, then the child should remain rear-facing,
choose a restraint that will suit larger babies in a
rear-facing mode.
475mm
To ensure that the space is sufficient, the purchaser should check the measurements
between the vehicle's rear and front seats in which the child restraint is intended to be used.
Ensure babies and toddlers are adequately shaded from direct sunlight through side or rear
windows.
Check the car is ventilated by opening windows or using the car's ventilation system taking in
external air. Recirculation setting is not suitable for providing ventilation.
THE TETHER STRAP MUST ALWAYS BE FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
Do not use the restraint without the top tether strap correctly attached.
The top tether strap must be attached to an anchorage point using an extension strap if
necessary.
The Baby Capsule may just touch the front seat, but must not in such a way that the
installation angle is affected.
Do not allow the front seat to alter the installed
position of the restraint, It is permissible to allow
the restraint to touch the seat in front of it.
Do not recline the seat excessively, it must be
installed at the correct angle (see page 21 - 22).
Do not use on any vehicle seat which faces
sideways or rearwards.
16
Instructions for Installation & Use