Britax Safe'n'Sound Instructions For Installation & Use page 30

BABY CAPSULE SETUP
SETTING UP THE HARNESS
This section covers the setting up of the harness to fit the infant. Fitting the harness is
not required. Securing of the infant is covered later in the instructions.
The Baby Capsule is fitted with three shoulder strap positions. As the baby grows the
shoulder straps must be moved to higher slots.
A. Sit the Baby Capsule on flat ground with
the handle rotated fully back to prevent
rocking.
B. Lengthen the harness straps by pressing
the harness adjuster (under the flap)
and pulling both shoulder harness straps
evenly. Release the buckle.
C. Move the two harness tongues to the
sides of the Baby Capsule and store
in the buckle tongue holder (if fitted)
(holders are on both sides of the padded
insert or the sides of the cover). Move
the harness buckle towards the harness
adjuster.
D. Place baby into Baby Capsule lying on
its back so that the buckle is between the legs.
E. Determine which Baby Capsule straps require adjustment to
fit the harness correctly:
Confirm crotch strap position required, followed by shoulder
straps position. Adjust as required following the instructions:
Crotch Strap - page 28
Shoulder Strap - page 29
Always remove baby from Baby Capsule prior to making
adjustments.
30
Instructions for Installation & Use
Press the
harness adjuster
and pull the
harness straps
to slacken.
Buckle Tongue
Holder (if fitted)