Britax Safe'n'Sound Instructions For Installation & Use page 29

ADJUSTING THE SHOULDER STRAPS
Remove infant from the Baby Capsule prior to making
adjustments.
A. At the rear of the Baby Capsule, remove one of the
harness shoulder straps from metal strap connector
by slipping strap through open slot. The metal strap
connector is shown in diagram right.
B. Pull the shoulder strap through slot to the front of the
Baby Capsule, through all the trims.
C. Feed shoulder strap back through desired slot in
padded insert cover and then
shoulder strap OVER bar
slot in the shell. Re-attach the straps to metal strap
connector at the back of the seat. The slot MUST
position the shoulder strap level with or the next slot
above the baby's shoulder.
If a Padded Insert is used, that will need to be re-
positioned and the strap re-inserted when changing
the slot position.
D. Refit the shoulder strap to the metal strap connector.
Ensure webbing is installed correctly over the bar.
Repeat straps A,B and C for the other strap.
Ensure both shoulder straps use the same height
slot pairs.
IMPORTANT :
When replacing straps, cover and padded insert, ensure none of the straps are
twisted and that all straps are secure by pulling each harness strap.
BABY CAPSULE SETUP
You MUST thread the
into the corresponding
ALWAYS OVER THE BAR
Metal Strap Connector
Instructions for Installation & Use
A
C
D
29