Installing The Base To The Car - Britax Steelcraft Instructions For Use Manual

HOW TO INSTALL
Consult the car owner's handbook for location of anchor fittings or
anchorage points. Some vehicle manufacturers recently have an
anchor fitting fitted in the car.
If there is no child restraint anchor fitting or child restraint anchor
point refer to page 49 for the installation of the anchor fitting as well
as the use of extension straps.
An anchor fitting is required to attach the upper anchorage strap to
fully install the Carrier to the car. The upper anchorage strap must be
used with this infant carrier when used in the car.
For installing the Base to the car, select a seating position with a child
restraint anchor fitting directly behind the seating position.
20

INSTALLING THE BASE TO THE CAR

A. Place the base and Infant Carrier
on vehicle seat in a seating
position where a child restraint
anchor fitting is installed. The Level
Indicator Line needs to be level
with the road, (ie parallel with the
road surface). Check and adjust
the recline angle of the base if
necessary.
B. If your car's seat is contoured then you
may need to adjust the angle of the base
so your baby is not too upright.
The recline angle may be altered using
the three position adjustment foot located
at the stabilising bar end of the base.
To adjust, pull out on angle adjustment
foot adjuster and lower or raise the angle
adjustment foot to the desired position.
Place back in the seating position and
check the Level Indicator Line.
Maximum
compensation
Road
HOW TO INSTALL
Level Indicator Line on
both sides of base.
Minimum
compensation
Road
21