Sleep Timer - Carrier P5 Series Owners And Installation Manual

UNIT OPERATION

Sleep Timer

Sleep timer procedure "night"
Press this button to set the SLEEP timer with remote control on. The icon will
appear on the display.
This procedure permits setting the remaining unit operating time.
1
"1:hr" will be displayed together with the icon.
2
Press button
The display will show the following settings in sequence:
1 hr, 2 hr, 3 hr, 4 hr, 5 hr, 6 hr, 7 hr, 8hr and 9 hr.
3
Once the remaining operating hours have been selected
with either button
confirm.
4
When the SLEEP timer is set, the unit will control the
set temperature to avoid overcooling or overheating
during operation. Also indoor fan operates at low fan
speed regardless of user selection.
The set temperature will change as follows:
NOTE
• When the SLEEP timer is set, the luminosity of the unit lamps will be dimmed
so as not to interrupt sleep.
• The SLEEP timer can be combined with the ON timer.
14
..........................................................................
(temperature increase).
or , again press button
Turbo mode and Ioniser function
Turbo mode button
If you want more powerful capacity at Cooling and Heating mode, press
button . On the display, the powerful icon
1
Turbo mode at Cooling mode
Performs the powerful cooling operation until room
temperature reach 17ºC or 20 minutes after pressing
turbo mode button.
At this mode, indoor fan speed is high and compressor
speed is over rating speed in order to obtain maximum
cooling capacity.
to
2
Turbo mode at Heating mode
Performs the powerful heating operation until room
temperature reach 32ºC or 20 minutes after pressing
turbo mode button.
At this mode, indoor fan speed is high and compressor
speed is over rating speed in order to obtain maximum
heating capacity.
During Turbo mode, you cannot control room temperature, and fan speed.
press one of the buttons
Ioniser function button
1
2
....................................................................................
will start flashing.
or to cancel the turbo mode.
...................................................................................
Press Ioniser button to activate Ioniser function
during unit ON.
Press Ioniser button
again to stop
Ioniser function.