Indoor Unit Installation; Installing The Wall Hang Bracket - Carrier P5 Series Owners And Installation Manual

INDOOR UNIT INSTALLATION

• The piping can be connected to the four directions indicated by
When the piping is connected to the direction of
out either at the side or at the bottom of the unit. ( Fig. 3 )

1) Installing the Wall Hang Bracket

, , , .
, or , detach the knock-
Figure 3
REMOVE SCREW
30cm
or more
• Install the wall hang bracket so that it is level. Use a plumb line if necessary.
( Figure. 4 )
• Be sure to leave the clearance spaces shown in Figure 1.
• Before installing the wall hang bracket, remove it from the unit by pushing up
marks ( ) at the bottom of the body.
• Fasten the wall hang bracket to the wall with 14 or more self-tapping screws
through the holes marked "
• Install the wall hang bracket so that there is no gap between the bracket and the wall.
• Check that the wall hang bracket does not move to prevent noise during
operation.
NOTE
• In case of removing the unit from the wall hang bracket after installing it
onto the wall, remove by pushing up MARKS ( ) at the bottom of
the body.
10cm
or more
45cm
or more
PLUMB
Figure 4
" at the wall hang bracket.
23