Carrier P5 Series Owners And Installation Manual page 9

BEFORE OPERATION
Matching Address between Indoor Unit and Remote Control
When two units are used in the same room, you can match the address of
the remote control to that of the unit.
Indoor Unit
Refer the page 35.
Remote control
Refer the page 34.
NOTE
• This function must only be performed by qualified service personnel.
Signal Receiving
Use the remote control where its signals can reach the receiver of the air
conditioner. (A distance of 5m is allowed)
• You can hear a beep from the unit which indicates that the signal is received.
5m maximum
CAUTION
• The air conditioner will not operate if curtained, doors or other
materials block the signals from the remote control to the unit.
• If the infrared signal receiver on the unit is exposed to direct sunlight, the air
conditioner may not work properly. Draw the curtains to avoid direct sunlight.
• A mounting bracket for the remote control is supplied with the unit.
Install the mounting bracket on the wall where the remote signal
can be easily received from the remote.
• If the room using the air conditioner has florescent lighting with
electronic starter, signals may not be properly received. If you are
planning to use such fluorescent lamps, consult your local dealer.
7