Configuration - Carrier P5 Series Owners And Installation Manual

CONFIGURATION

Remote Control Configuration
• Remote Control is used for heat pump type air conditioner and cool only type
air conditioner.
Before user operates air conditioner, thus, cool only type and heat pump
type of remote configuration and other items must be selected as follows.
1
Press the and
and hold them pressed for more than 5 seconds.
2
The display will be cleared, the temperature segments will
display the first configuration item (CH = remote address) and
the time segments will display the default value of this
configuration item (Ab = control of both indoor units).
3
Press either the or
(A) to the new value (b).
4
Press button repeatedly until "tU" is displayed.
5
Press either the or
temperatures in Degrees Celsius (C) to the new value
Degrees Fahrenheit (
6
Press button repeatedly until "rc" is displayed.
7
Press either the or
Heat pump in model type (HP) to new value cooling only
type(co).
8
Press button repeatedly until "HR" or "CR" is displayed.
9
Press either the or
Maximum heating setpoint or minimum cooling setpont.
10
Press button repeatedly until "CL" is displayed.
34
buttons of the infrared remote controller
button to change the default value
button to change the default value of
F).
o
button to change the default value of
button to change the default value of
11
Press either the or
time format as AM/PM (12) to the new value of 24 hours time
format (24).
12
LOOK OUT! Whichever configuration value changed must
be confirmed pressing
13
Press button to leave the configuration menu.
NOTE
When 30 seconds have elapsed and no buttons have been pressed, the
remote controller will automatically exit the configuration menu and the
procedure has to be restarted.
Confirguration item
A : Channel A
"CH"
Ab : Channel A and B
b : Channel B
C : Degrees C
"tU"
F : Degrees F
HP : Normal Operation
"rc"
CO : Cooling Only
17-32 : 17°~32°C
"HR" 63-90 : 63° ~ 90°F
17-32 : 17°~32°C
63-90 : 63° ~ 90°F
"CR"
12 : 12 Hour Standard
(AM/PM)
"CL"
24 : 24 Hour Military
button to change the default value of
button each time.
Value Description
Remote ID selection
Defaults to A
Temperature units
Defaults to C
Puts the Remote into
Cooling Only Mode
Defaults to HP
Maximum heating setpoint
Degrees C or F is determined
by "tU"configuration above
Minimum cooling setpoint
Degrees C or F is determined
by "tU" configuration above
Time Format
Defaults to 12