Before Operation - Carrier P5 Series Owners And Installation Manual

Indoor Unit Display
Ioniser(Left) light : illuminated during Ioniser activated.
Timer(Middle) light : illuminated during timer mode.
Power(Right) light : illuminated during operation.
EMER. button
Emergency Operation
When the remote control is lost, damaged or the battery is discharged, the EMER. button can be used to run the unit.
• Press the EMER. button once briefly at the off mode condition shorter than for 5 sec.
- According to the room temperature, the unit operates the Cool mode in cool only model and the Auto mode
in Heat pump model.
• If you want to stop the emergency operation, push the EMER. button again or operate the remote control.
• The setting conditions of emergency operation are as follows:
Model Operation Preset mode
Cooling
COOL
only
Heat
AUTO
Pump
Timer mode
Fan speed
temperature
24°C AUTO Disable
25°C AUTO Disable
Test Operation
This operation is used for checking after unit installation.
• Press the EMER. button continuously during 5~10sec. And then unit will be
operated as test mode.
• Press the EMER. button once more after checking to activate the remote
control. If there is any input signal ( remote control signal or EMER. button
press ) during test operation, the TEST mode will change to the input
signal mode.
• The setting conditions of the test operation are as follows:
- Operation mode : COOL
- Timer mode : Disable
Discharge air direction
Horizontal
Preset location according
to 'Cool' or 'Heat' mode

BEFORE OPERATION

- Fan speed : HIGH
- Discharge air direction : SWING
EMER.
button
• EMER. button :
Can be used when the remote
control is lost or inoperative.
5