Configuring The Output - TDK-Lambda GENESYS Series User Manual

11.1.3. Examples of Alternative Forms of SCPI Command
For a command:
[SOURce:]VOLTage:PROTection:LEVel <nn.nn|MAX>
The following are correct forms of the same command:
SOURCE:VOLTAGE:PROTECTION:LEVEL MAX
:VOLTAGE:PROTECTION:LEVEL MAX
VOLT:PROTECTION:LEVEL MAX
VOLT:PROT:LEV MAX
:volt:prot:lev max
The following are invalid forms of the command and will cause an error:
CURRENT:PROTECTION:STATE
:CURRENT: PROTECTION:STATE MAX
:CURR:PROTEC:STATE ON

11.2. Configuring the Output

11.2.1. Set the Voltage Limit
This command sets the voltage limit. When the power supply is running in constant-
voltage mode, this will be its output voltage
The voltage limit, rounded to four digits, may be viewed on the supply front panel by
pressing and releasing the PREView button
Syntax:
Parameter:
Examples:
Query:
Errors:
8303460000 Rev A
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
<nn.nn>
<nn.nn> is volts, the acceptable range is:
from 5% more than the under-voltage (UVL) setting
to 5% less than the over-voltage protection (OVP) setting
VOLT 18.5
:VOLT 18.5
VOLT? will return 18.5 in the example
(this may be different than the actual output voltage)
SYSTEM:ERROR? may return errors including:
-222, "Data out of range"
+301, "PV above OVP"
+302, "PV below UVL"
38
(longest form of command)
(SOURCE and colon are optional)
(Abbreviate VOLTAGE)
(Shortest form of command)
(Small letters acceptable)
(missing parameter, MAX or number)
(no spaces in command)
( PROTEC is not complete abbreviation)
IA672-04-01-Rev. I