TDK-Lambda GENESYS Series User Manual page 28

LAN  Configure  Modify Page
6.6.2.
The "Modify" button on the "LAN  Configure" page allows you to change the LAN
settings. You must be logged-in as 'admin' to enable the button.
DHCP Enabled / Auto IP
This is the default setting for the Genesys™ LAN.
When the DHCP Enabled / Auto IP radio button is selected, only the following
settings may be changed. The disabled settings (grayed) are set by the network's
DHCP server.
Hostname: the hostname may be used instead of the IP address to make a
connection if the network supports the DNS service for name translation. You
may enter a custom name that describes the power supply in a meaningful way.
Description: the description may be viewed on the web Home page. It is also
advertised as the power supply's service name if your network supports the
DNS-SD protocol. You may enter a custom description that describes the power
supply in a meaningful way.
Controller Access: Select the security feature for "One client only" or "Multiple
clients". The multiple client setting is needed to allow more than one controller
connection at a time and to enable UDP socket connections. See section 9.3 for
details.
Apply: Click this button to save the new settings. A pop-up box will ask you to
close or refresh the page. Your 'admin' log-in will be logged-out.
Close: Click this button to return to the LAN Configure Page shown in
section 6.6.1
8303460000 Rev A
To restore the hostname to the factory default,
clear the hostname text box and click "Apply"
To restore the description to the factory default,
clear the description text box and click "Apply"
27
IA672-04-01-Rev. I