TDK-Lambda GENESYS Series User Manual page 25

DC Power  Protection Page
6.5.2.
On the "DC Power" tab, a "Protection" button is available at the top of the panel.
When opened, the window that allows you to view and set four protections. The
"Apply" buttons are not enabled until you log in
The four settings are:
A. Over-Voltage Protection
B. Under-Voltage Limit
C. Foldback Protection ON or OFF
D. Auto-Start or Safe-Start
In a multi-drop chain, these settings affect only the supply selected in the RS-485
address listbox
DC Power  System Page
6.5.3.
Under the "DC Power" tab, a "System" button is available at the top of the panel.
When it is clicked, the window that allows you to operate four functions:
A. Reset One Instrument
(this resets only the supply selected in the multi-drop listbox)
B. Reset All Instruments
(this resets any supplies connected to the multi-drop bus)
C. Save
(this saves the settings for only the supply selected in the multi-drop listbox)
D. Recall
(this recalls the settings for only the supply selected in the multi-drop listbox)
8303460000 Rev A
(see section 11.5.1)
(see section 11.5.2)
(see section 11.5.4)
(see section 11.4.3)
(see section 11.7.2)
(see section 12.4.7)
(see section 11.7.3)
(see section 11.7.4)
24
IA672-04-01-Rev. I