TDK-Lambda GENESYS Series User Manual page 47

11.7.2. Reset the Power Supply
This command will reset all settings in the power supply to a known, safe state. This
includes setting the programming limits to zero, output off, and auto-restart off. Other
protections are disabled. Sending *RST is the same as sending all nine of the
following commands:
VOLT 0
OUTP:STAT OFF
OUTP:PON OFF
VOLT:LIM:LOW 0
This has no effect on the LAN configuration or connection settings.
Syntax:
11.7.3. Save All Settings
This saves the present power supply settings. This is used along with the *RCL 0
command (in section 11.7.4) which allows you to bring the power supply back to
some setup configuration with only one command
When the supply is powered-down, the *SAV 0 settings are over-written by the
power-down settings
Syntax:
11.7.4. Recall All Settings
This recalls the last saved power supply settings. These may be from the last *SAV 0
command (in section 11.7.3) or, if no *SAV 0 has been sent, the last settings
restored at power-up.
The recall command will change the following settings with only one command, where
<last> are the last settings from *SAV 0 or from power-up.
The status and event registers are not affected by the recall command
Syntax:
11.7.5. Self-Test
This is query to launch a simple self-test. It verifies the basic connections between the
LAN microcontroller and the control board microcontroller. The self-test result (pass
or fail) is read from the message queue.
If the self-test failed and it returns 1, contact TDK-Lambda Americas Inc. Customer
Service for further instructions.
Syntax:
Responses:
8303460000 Rev A
*RST
*SAV 0
VOLT <last>
OUTP:STAT <last>
OUTP:PON <last>
VOLT:LIM:LOW <last>
*RCL 0
*TST ?
0
when the self-test passed
1
when the self-test failed
46
CURR 0 *CLS
SYST:SET REM
CURR:PROT:STAT OFF
VOLT:PROT:LEV MAX
CURR <last>
SYST:SET <last>
CURR:PROT:STAT <last>
VOLT:PROT:LEV <last>
IA672-04-01-Rev. I