Initial Setup; Configuring The Mer 9600C - Uniden MER 9600C Manual

Table of Contents

Advertisement

Configuring the MER 9600C

Before you can place or receive calls, you must configure your
MER 9600C to match the operation of your host telephone. You
must configure one of the Function Buttons (1 – 4) as your primary
extension.
If you press talk key before
you configure the phone, you
will see an error message on
the LCD:
1. Remove the handset from the base unit.
2. Press and hold the
3. While holding
4. Release all 3 keys. You will
now see a message on the
LCD prompting you to
configure the F1 function key.
You can assign any function to F1 that you have on your
Note:
Host Telephone. For example; this can be a line key, call
forwarding key, pickup key, etc.
A * in the display indicates
that function key has already
been programmed.
5. Press the key on the Host Telephone that has the function you
want to assign to F1 . You will hear a beep to acknowledge that
the function has been assigned to the key, and a * will appear
to the lower right on the LCD.
6. You will see a new message
on the LCD prompting you to
configure F2 .
Follow the same procedure you used for F1 . Proceed in the same
way for F3 , F4 , xfer , and conf .

Initial Setup

#
and
keys at the same time.
#
and
, press the talk key.
23
NO CONFIG
PROGRAM
BTN F1
PROGRAM
BTN F1
*
PROGRAM
BTN F2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MER 9600C and is the answer not in the manual?

Table of Contents