EcoWater Timetronic 314 User/Installer Handbook page 37

'
CHECKLIST SOLUTION
1
PAGE REF.
1
1
TlMETRONlC
1
SENSATRONIC
1
I N 0 RECHARGE OCCURRING. OR LIlTLE OR NO SALT USAGE
4. Sensatronic only
-
Check the
capacity bar, is the % remaining high?
4. Check the meter sensor
connections.
Check that there is a flow reading.
,
PROBLEM: EXCESSIVE SALT USAGE
I. Timetronic only
-
Check the
hardness against the days of
recharge and fill time.
1
1. Reduce settings if incorrect.
I
PROBLEM: NO WATER I N CABINET OR VERY LOW
1
2. Sensatronic only
-
Check the
hardness.
3. Sensatronic only -
Check the
average.
1. 'This is quite normal. Unlike
conventional water softeners only a
few inches of water is at the
bottom of the cabinet.
2. Reduce the unit setting if.
incorrect.
3. If your water usage is high, then.
I
this may be correct.
I. No action necessary.
1
PROBLEM: HIGH WATER LEVEL IN CABINET
I. Is the water level in the brine
cabinet high?
PROBLEM: WATER RUlVNlNG DOWN THE DRAIN LINE CONSTANTLY
1. Is the water level in the salt
cabinet high?
1. Is the unit in recharge mode?
PROBLEM: WATER RUNNING DOWN THE OVERFLOW
1. Initiate an immediate regeneration.
If the problem does not return,
there is nothing wrong.
2. Does an error code appear,
eg. "ERROI"?
I. If yes, bypass the water softener
and call for service.
1. If yes, wait until it finishes, check
the present time and recharge
time settings, and adjust if
incorrect.
16
2. Check all connections are
secure.
Turn the power off for 10 seconds
and then turn back on.
Press the Recharge button one
23
6, 3 7 6, 3 7
If the problem persists, bypass the softener and call for a Service.
1. Is the faceplate blank?
2. Is the display stuck in one function?
3.
Does an error code appear,
eg.
"ERROl"?
PROBLEM: FACEPLATE PROBLEMS
6, 3 7 6, 37
1. Check the power is turned on
and all connections are secure.
2.
Turn the power off for 1 0 seconds
and then switch back on.
3.
Check all connections are secure.
Turn the power off for 1 0 seconds
and then turn back on.
9
9
9
9
9
9