EcoWater Timetronic 314 User/Installer Handbook page 15

SETTHE TIME OF RECHARGE
NOTE
The display should now be steady and read
the correct time and day of the week. Only
the hour minute/separator will flash as it is
pulsing once a second. If an houj minute, or
day display is flashing press the TIME & DAY
button once. Repeat pressing the TIME& DAY
buff on until the display steadies.
The unit is factory set t o recharge at 2.00
a.m. If you wish t o change this time then
proceed as follows: (if not proceed t o the
next section).
NOTE 2.00 a.m. is chosen because hard
water will enter the system during recharge.
Consequently a time is required when very
little, if any, water will be used.
\
€ ! I
0
To advance the recharge time
press the SETICLEAR button.
Each time you press the
a
SETICLEAR button you will
advance the time by one hour.
Advance the recharge time t o
@
the required hour.
\
@
Press the RECHARGE TIME
button once.
0
The display will show the time at
which the recharge is set t o take
place and the days on which this
will occur.
0
Press the TIME & DAY button
t o set.
SET'THE REQUIRED DAYS OF
\
RECHARGE
The unit is factoryset t o recharge on Monday,
Wednesday and Friday. You may wish t o set
the days around your own household
requirements or t o set the days of recharge
according t o our user guide on page 36.
0
Press the RECHARGE day button
once and SU (Sunday) begins t o
flash and 'OFF' will be displayed.
This means the unit will not
recharge on Sunday.
n