TO RECHARGE NOW
An automatic recharge can be initiated at
any time. If you have guests visiting or expect
t o use more water than usual, you may run
out of softened water. If the unit is not due
t o recharge for another day or two and you
think you may run into hard water then an
automatic recharge will prevent this from
happening.
At the end of the recharge the
time display will return t o normal.
HOLIDAYS OR LONG WEEKENDS
As your unit is programmed t o recharge on
set days it will waste water and salt even if you
are not there. To overcome this you need to
switch the unit off but still keep the time
and cycle setting which have been
pre-programmed.
Do not switch the unit off at the mains.
On return from your holiday.
rn
Press the ON/OFF button once
w
t o return the unit t o service. If
this is not done the unit will not
recharge and hard water will
enter the system.
The correct time
and
day
will
0
show in the display.
\
10
Press and hold the ON/OFF
button until RCHG shows in
RCHG will flash in the display
during the recharge which lasts
for approximately 1 hour.
Use as little water as possible
during this time period as hard
water will bypass the water
softener.
\
lm
0
Press the ONIOFF button once
(DO NOT HOLD DOWN).
0
VAC (Vacation) will flash in 'the
display. The timer will keep time
but not recharge t o waste salt or
0
water.
@,
If the correct Time & Day do not re-appear a
power cut may have occurred whilst you
were away.
The following section describes the
procedure for power cuts.
Need help?
Do you have a question about the Timetronic 314 and is the answer not in the manual?