EcoWater Timetronic 314 User/Installer Handbook page 17

SETTHE FILL CYCLE MINUTES
The unit is factory set to fill the unit with
water for 16 minutes to soak the salt and
produce brine for re-charge. If the time
setting for the cycle is too low you may
get hard water between re-charges. If the
time setting is too high you will waste salt.
Refer to the user guide on page
36
for the
required setting for your particular unit.
\
@
Press and hold the RECHARGE
0
TIME button until Fill shows in
the display.
0
After a few seconds, the fill cycle
setting will display and flash.
0
Once the required setting is
reached press the TIME & DAY
button once t o set.
m
\
n
To advance the fill cycle press
the SET/CLEAR button.
0
Each time you press SET/CLEAR
the fill cycle will advance by one
minute.
0
Advance the fill cycle until
required setting is displayed.The
display will advance t o 59 then
@
begin again at 0.
0,
*NOTETO INSTALLER
-
YOU MAY RETURN TO PAGE 10