Required Tools - Enterasys 7100G Series Hardware Installation Manual

Follow the order of the sections listed below for correct installation:
For information about...
Required Tools
Installation Site Requirements
Unpacking the 7100G-Series Switch
Mounting the 7100G-Series Switch
Unpacking the Power Supplies
Installing the Power Supplies
Powering Up the 7100G-Series Switch
Connecting to the Network
Multiple 7100G-Series Chassis Stacking (Virtual Switch Bonding)
Connecting to the COM Port for Local Management
Completing the Installation
Read the Release Notes specific to the firmware image running in the chassis to check for any
exceptions to the supported features and operation documented in this guide.

Required Tools

• ESD wrist strap (included with the 7100G-Series switch)
• Phillips screwdriver
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Risques d'électrocution: Seul un personnel qualifié doit effectuer les procédures d'installation.
Important Notice
Enterasys 7100G-Series Hardware Installation Guide 2-1
2
Installation
Refer to page...
2-1
2-2
2-2
2-3
2-12
2-12
2-14
2-15
2-18
2-19
2-21