Mounting the 7100G-Series Switch
To install the 7100G-Series switch in a rack using the 71A-RACK-U optional rack mount kit, follow
the pre-installation discussion here including:
Air
Flow" on page 2-4 and
to
"Optional Rack Mount Rail Kit
You can install a 7100G-Series switch on a flat surface or in a rack. For more information about flat
surface installation, see
There are four possible rack mounting configurations as shown in
whether:
•
The switch I/O ports side or the power supply side of the device face front
•
The device is mounted flush with the rack posts or mid-mounted
Figure 2-1
1
Flush mounted with the switch I/O ports facing 3
front (cool air side)
2
Flush mounted with the power supply facing
front (cool air side)
Note: The 7100G-Series switch comes with integrated mounting ears that are adequate for most
installations. For slide-in mounting, high vibration, or high shock installations, an optional rack
mount kit (71A-RACK-U) is available.
"Reversing the Fan Module Air
"Flat Surface
7100G-Series Switch Rack Configurations
"Power Supply Air Flow and Switch Fan Module
Installation" on page C-1.
Installation" on page 2-12.
Mid-mounted with the switch I/O ports facing front
4
Mid-mounting with the power supply facing front
5
Air flow direction
Enterasys 7100G-Series Hardware Installation Guide 2-3
Mounting the 7100G-Series Switch
Flow" on page 2-5, before proceeding
Figure
2-1, based upon