ELECTRICAL HAZARD: Only qualified personnel should install the 1H582-xx.
NOTE: Read the Release Notes shipped with the device to check for any exceptions to
the supported features and operation documented in this guide.
This chapter provides the instructions required to install the 1H582-xx. Follow the order of the
sections as listed below to correctly install the device.
•
Unpacking the device
•
Installing options
•
Installing the device (on a shelf or tabletop, or into a standard rack)
•
Connecting to the network
•
Completing the installation
3.1
REQUIRED TOOLS
A Phillips screwdriver is required to install the device into a rack and to install an Ethernet
expansion module.
(Section
3.2)
(Section
3.3)
(Section
3.8)
(Section
3.10)
Hardware Installation
(Section
Hardware Installation
3
3.7)
3-1