Pluggable Transceiver Specifications; Com Port Pinout Assignments; Com Port Pin Assignments - Enterasys 7100G Series Hardware Installation Manual

Pluggable Transceiver Specifications

Table A-2
switch.
Table A-2 Specifications
Item
Physical (7100G-Series Chassis)
Dimensions
Approximate Weight
Mean Time Between Failure (MTBF)
71A-POE-A or 71A-POE-B
Input Frequency
Input (Voltage/Current) at Output Power
Approximate Weight
71A-PS-A or 71A-PS-B
Input Frequency
Input (Voltage/Current) at Output Power
Approximate Weight
Environmental
Operating Temperature
Storage Temperature
Operating Relative Humidity
Pluggable Transceiver Specifications
For SFP+ and QSFP+ transceiver specifications, refer to the datasheet at the following URL:
http://www.enterasys.com/products/transceivers-ds.pdf

COM Port Pinout Assignments

The COM port is an RJ45 communications port for local access to local management. Refer to the
table below for the COM port pin assignments.
Table A-3 COM Port Pin Assignments
Pin
1
2
3
4
5
6
7
A-2 Specifications
describes physical, electrical, and environmental specifications for the 7100G-Series
Signal Name
Transmit Data (XMT)
Data Carrier Detect (DCD)
Data Set Ready (DSR)
Receive Data (RCV)
Signal Ground (GND)
Data Terminal Ready (DTR)
Request to Send (RTS)
Specification
4.37 cm H x 44.73cm W x 43.40cm D
1.72" H x 17.61" W x 17.086" D
Gross: 7.12 kg (15.7 lb)
Refer to the MTBF web site at URL
http://www.enterasys.com/support/mtbf/
50 to 60 Hz
100 to 240 V AC: 10 - 5A at 800 watts
0.86 kg (1.90 lb)
50 to 60 Hz
100 to 240 V AC: 5.29 to 2.2A at 450 watts
0.86 kg (1.90 lb)
5°C to 40°C (41°F to 104°F)
-30°C to 73°C (-22°F to 164°F)
5% to 95% (non-condensing)
Input/Output
Output
Output
Input
Input
NA
Output
Input