Christie HS Series Installation And Setup Manual page 32

4. Refocus position 1 and check if position 2 is also in focus. If not, repeat step 3 and 4 until both
position 1 and 2 are in focus.
5. To optimize the focus of position 3 on the screen, turn set screw C clockwise or counterclock-
wise.
6. Repeat from step 2 until the projected focus pattern is as sharp as possible in the center, left,
right, top, and bottom of the screen.
7. If the projector is still not in focus, reset the set screw position:
a. Turn the set screws counterclockwise until tight.
b. Turn the set screws 1.5 turns in the clockwise direction back to their factory default
setting.
c. Check that the alignment of the set screws matches what is shown in the image
above.
HS Series D16-20 Installation and Setup Guide
020-001464-02 Rev. 1 (10-2018)
Copyright ©2018 Christie Digital Systems USA Inc. All rights reserved.
Installation and setup
32