Table of Contents
Advertisement
2.3 The phases of the tanning
programme
The tanning programme of the equipment includes
•=
tanning time
•=
cooling time
Tanning time
After the warm-up phase is over, all of the equipment
components are ready for operation and the selected
tanning time begins.
Cooling time
At the end of the tanning time, some equipment
components continue to run such as the fan in order to
cool off the sunbed.
2.4 Settings
The settings can be changed with the buttons on the
control panel (1) as described in section 4.7.1.
2.5 Display
1
04002 / 0
Depending upon the sunbed mode, the following will
appear in the display (1):
•=
The 7-segment display flashes in the display
when the the sunbed is in standby mode.
•=
During the tanning process the tanning time or
the cooling time is displayed in minutes. The
counting method of the times displayed depends
upon the control device fitted.
•=
Coin device: time display counting upwards
Description
1
2
3
4
5
6
1
04003 / 0
7
8
9
10
11
17
Advertisement
Table of Contents
