Mvme2700 Base Board Preparation; Table 1-2. Jumper Settings - Motorola MVME2700 Series Installation And Use Manual

Hardware Preparation and Installation
1

MVME2700 Base Board Preparation

1-6
Figure 1-2 illustrates the placement of the switches, jumper headers,
connectors, and LED indicators on the MVME2700. Manually
configurable items on the base board are listed in the following table. Refer
to the sections or figures listed along side the jumper function for more
information.

Table 1-2. Jumper Settings

Jumper
J9 Flash Bank Selection (J9) on page 1-8
J20 System Controller Selection (J20) on page 1-11
J18 Serial Port 3 Transmit Clock Configuration (J18) on page 1-10
J16 Serial Port 4 Receive Clock Configuration (J16) on page 1-8
J17 Serial Port 4 Transmit Clock Configuration (J17) on page 1-9
J19 Serial Port 4 Transmit Clock Receiver Buffer Control (J19) on
page 1-9
In conjunction with the serial port settings on the base board, serial ports
on the associated MVME712M or MVME761 transition module are also
manually configurable. For a discussion of the configurable items on the
transition module, refer to the
Preparation and MVME761 Transition Module Preparation
further information, refer to
The MVME2700 is factory tested and shipped with the configurations
described in the following sections. The MVME2700's required and
factory-installed debug monitor, PPCBug, operates with those factory
settings.
Function
MVME712M Transition Module
Appendix D, Related Documentation.
Computer Group Literature Center Web Site
sections. For