Default Processor Memory Map; Table 2-2. Processor Default View Of The Memory Map - Motorola MVME2700 Series Installation And Use Manual

Default Processor Memory Map

The default processor memory map that is valid at power-up or reset
remains in effect until reprogrammed for specific applications.
defines the entire default map ($00000000 to $FFFFFFFF).

Table 2-2. Processor Default View of the Memory Map

Processor Address
Start
00000000
80000000
80020000
FEF80000
FEF90000
FEFF0000
FF000000
FFF00000
Notes
1. Default map for PCI/ISA I/O space. Allows software to determine
2. The first 1MB of ROM/Flash bank A (socketed 1MB ROM/Flash)
For detailed processor memory maps, including suggested CHRP- and
PREP-compatible memory maps, refer to the MVME2600/2700 Series
Single Board Computer Programmer's Reference Guide.
http://www.motorola.com/computer/literature
Size
End
7FFFFFFF 2GB
8001FFFF 128KB
FEF7FFFF 2GB-16MB-
640KB
FEF8FFFF 64KB
FEFEFFFF 384KB
FEFFFFFF 64KB
FFEFFFFF 15MB
FFFFFFFF 1MB
whether the system is MPC105-based or Falcon/Raven-based by
examining either the PHB Device ID or the CPU Type register.
appears in this range after a reset if the rom_b_rv control bit in the
Falcon's ROM B Base/Size register is cleared. If the rom_b_rv
control bit is set, this address range maps to ROM/Flash bank B
(soldered 4MB or 8MB ROM/Flash).
Memory Maps
Definition
Not Mapped
PCI/ISA I/O Space
Not Mapped
Falcon Registers
Not Mapped
Raven Registers
Not Mapped
ROM/Flash Bank A or
Bank B
2
Table 2-2
Notes
1
2
2-5