Sntp - Ricoh Pro C9100 Operating Instructions Manual

3. Monitoring and Configuring the Machine
Configuring an SNMP v3 authentication algorithm
msh> snmp v3auth algo {md5|sha1}
Configuring an SNMP v3 encryption algorithm
msh> snmp v3priv algo des/aes
Configuring SNMP v3 encryption
msh> snmp v3priv mode {auto|on}
• Set "auto" for automatic encryption configuration.
• If you select "on", plain-text communication becomes impossible - only encrypted
communication is possible.
• "Encrypted communication" means an encrypted password is set on the machine.

sntp

The machine clock can be synchronized with an NTP server clock using Simple Network Time Protocol
(SNTP). Use the "sntp" command to change the SNTP settings.
View settings
msh> sntp
NTP IPv4 server address configuration
You can specify the IPv4/IPv6 address of the NTP server.
msh> sntp server "IPv4/IPv6_address"
NTP hostname configuration
You can specify the hostname of the NTP server.
msh> sntp server "hostname"
Deleting NTP server configuration
msh> sntp server clear
Interval configuration
msh> sntp interval "polling_time"
• You can specify the interval at which the machine synchronizes with the operator-specified
NTP server. The default is 60 minutes.
• The interval can be entered from 0, or between 15 and 10,080 minutes.
• If you set to "0", the machine synchronizes with the NTP server only when you turn the
machine on. After that, the machine does not synchronize with the NTP server.
92