Ricoh Pro C9100 Operating Instructions Manual page 47

12. Press [Change] under "Search Base".
Select a root folder to start a search. E-mail addresses registered in the selected folder are search
targets.
13. Enter the search base, and then press [OK].
For example, if the search target is the sales department of ABC company, enter "dc=sales
department, o=ABC". (In this example, the description is for an active directory. "dc" is for the
organization unit, and "o" is for the company.)
Search base registration may be required depending on your server environment. When the
registration is required, unspecified searches will result in error.
Check your server environment and enter any required specifications.
14. Under "Use Secure Connection (SSL)", press [On].
Use SSL to communicate with the LDAP server.
For SSL function, the LDAP server must support SSL.
If you set SSL to [On], the port number automatically changes to "636".
If you do not enable SSL, security problems may occur. To enable SSL, you must use the machine's
settings. For details, see Security Guide.
15. Press [Change] under "Port No. ".
Specify a port number for communicating with the LDAP server. The port must be compliant with
your environment.
16. Enter the port number using the number keys, and then press the [ ] key.
17. Press [ Next].
18. Select an authentication method.
To make a search request to the LDAP server, the administrator account can be used for
authentication.
Authentication settings must comply with your server's authentication settings. Check your server
settings before setting this machine.
• [Kerberos Authentication]
A password protected with encryption is sent to the KDC server where authentication is
performed.
• [Digest Authentication]
A password protected with encryption is sent to the LDAP server.
Digest Authentication is only available with LDAP version 3.0.
• [Cleartext Authentication]
A password without encryption is sent to the LDAP server.
• [Off]
Programming the LDAP Server
45