Flywheel - Stihl MS 200 Service Manual

: Use a pointed tool to pierce the
center of the other end of the
ignition lead which screws into
the module.
Do not use either graphite grease or
silicone insulating paste.
– Install the ignition module,
b 9.2.1
1
: Pull out the ignition lead (1) at the
clutch side until the ignition lead
is properly seated at the ignition
side of the crankcase.
The ignition lead (1) and short
circuit wire (2) must lie in the guide
(arrow) and not project
– there is otherwise a risk of
damaging the insulation and
causing a short circuit.
– Install the flywheel and adjust the
air gap, b 9.4, b 9.2.1
50
1
: Push the ignition lead (1) into the
guides (arrows).
The ignition lead must be properly
seated to avoid it being pinched
when the oil pump is installed.
– Install the oil pump, b 13.4
2
: Fit the boot on the spark plug and
push the retainer (arrow)
between the cylinder fin and tank
housing.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
9.4

Flywheel

1
– Remove the chain sprocket
cover, bar and chain, b 5
– Remove the fan housing, b 10.2
– Use locking strip (1) to block the
piston, b 6
: Unscrew the flywheel nut (arrow).
If the flywheel is stuck, use a puller.
MS 200, MS 200 T