Spa Pool Cover Lifter (Optional Extra); Pre-Fill Procedure; Steps To Prepare For Filling - Alpine Spas SPA POOL Manual

Spa Pool Cover Lifter (Optional Extra)

The cover lifter needs to be assembled onto the spa pool, please see the
instructions in the cover lifter box and follow them carefully. Two brackets need to
be secured into opposite sides of the spa pool cabinet. Certain setups may have
restrictions - see our 'Cover Lifter Installation Guide' for confirmation.
Download the 'Cover Lifter Installation Guide' from our support page:
http://alpinespas.co.nz/support/

PRE-FILL PROCEDURE

BEFORE FILLING, START HERE!
FAILING TO FOLLOW THIS PROCEDURE MAY RESULT
IN ISSUES STARTING UP THE SPA POOL OR VOIDING WARRANTY.

Steps to Prepare for Filling:

1
Check the silver plaque on the
side of spa pool cabinet (or see
your invoice) to find your spa pool
model's name. See pages 34 - 77
for more specific info about your
spa pool.
4
Check the external drain valve
is in the 'flow-locked' position
(extended) with the inner twist cap
screwed in tight.
2
As the spa pool has been water
tested during manufacture,
excess water residue may have
splashed out from within the
pipes during transport and may
require a quick wipe.
5
Remove the 3M™ blue protective
film from the stainless steel strip
that surrounds the edge of the
acrylic.
3
Open all of the spa pool jets by
turning them anti-clockwise. This
will allow water to flow through all
pipes when filling and help avoid
air-locks.
11