Alpine Spas Triumph Setup
  1. Manuals
  2. Brands
  3. Alpine Spas Manuals
  4. Hot Tub
  5. Triumph
  6. Setup

Alpine Spas Triumph Setup

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

ELECTRICAL PACK

ELECTRICAL PACK
Triumph - Advanced Swim

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Triumph and is the answer not in the manual?

Questions and answers

Related Manuals for Alpine Spas Triumph

Summary of Contents for Alpine Spas Triumph

  • Page 1 ELECTRICAL PACK ELECTRICAL PACK Triumph - Advanced Swim...
  • Page 2 The Triumph - Advanced Swim uses the SpaNET SV3 Controller. By default, only 32A is required to run the controller in the Triumph - Advanced Swim. However, you can alter the settings and hardwire a 45A feed so that the heater can run better while all the pumps are in use.
  • Page 3 WIRING DIAGRAM CONTROLLER WIRING DIAGRAM (SV3) This controller can be wired single, dual or three phase. See below diagrams. Ensure DIP switches are set correctly. No cable and/or electrical equipment (RCD etc.) is provided. DIPS DIPS DIPS...
  • Page 4 TOUCH PAD SETTINGS Before Powering On Ensure that the Swim Spa is filled with water before turning on the power. If the Swim Spa still requires filling, you will need to power on and apply settings with pump disconnected. Swim Spa is Filled - Touch Pad & Startup Once the Swim Spa is filled, turn on the power and locate the touch pad (seen below).

Table of Contents