Table of Contents
Advertisement
10.4.2
Configuration area „General settings"
Menus
Detailed view "parameter"
büS
Displayed name
Location
Description
Advanced
Unique device name
Baud rate
CANopen address
Bus mode
CANopen status
Deallocation delay
Alarm limits
Supply voltage
Error high
Error low
Hysteresis
Device temperature
Error high
Error low
Hysteresis
Diagnostics
PDO Configuration
PDO 1
Reset to default values
Demo mode
Display
Brightness
Contrast
Setup
28
Description/factory settings (if available)
Device name, can be changed without affecting communication.
Device installation location, displayed with the device name.
Free description text, is used for example in tooltips.
Factory default number code .
Used for partner assignments and should therefore not be
changed!
50, 125, 250, 500 kbit/s or 1 Mbit/s
Entry of address/node ID.
If the address is already used, the device will switch to a different
address (only in büS mode).
CANopen, büS
This menu is only displayed if "CANopen" is set as the bus mode.
0.5 s
Time between loss of a partner and deletion of its configuration.
Entry is possible, but usually does not need to be changed. This
value only has an effect if in büS mode.
26.4 v
21.6 v
1.0 v
85°c
–20 °c
2.0°c
Switch complete diagnostics on or off
Enter the transmission times
10 ms
2s
event timer
Reset PDO settings
Off
Special mode for trade fairs and presentations
Display
70 %
50 %
Entry of base settings via a start-up wizard
english
or standalone device
inhibit time
Type 8653
Pneumatic connection
Advertisement
Table of Contents
