Siemens Sinumerik 840D sl Programming Manual page 182

Data lists
D.1 Machine data
Number Identifier
10888 EXTERN_DIGITS_TOOL_NO
10890 EXTERN_TOOLPROG_MODE
18800 MM_EXTERN_LANGUAGE
Channelspecific ($MC_ ... )
20050 AXCONF_GEOAX_ASSIGN_TAB[ ]
20060 AXCONF_GEOAX_NAME_TAB[ ]
20070 AXCONF_MACHAX_USED[ ]
20080 AXCONF_CHANAX_NAME_TAB[ ]
20094 SPIND_RIGID_TAPPING_M_NR
20095 EXTERN_RIGID_TAPPING_M_NR
20150 GCODE_RESET_VALUES[n]: 0 to max. number of G
codes
20152 GCODE_RESET_MODE
20154 EXTERN_GCODE_RESET_VALUES[n]: 0-30
20380 TOOL_CORR_MODE_G43G44
20382 TOOL_CORR_MOVE_MODE
20732 EXTERN_G0_LINEAR_MODE
20734 EXTERN_FUNCTION_MASK
22420 FGROUP_DEFAULT_AXES[ ]
22512 EXTERN_GCODE_GROUPS_TO_PLC[n]: 0-7
22900 STROKE_CHECK_INSIDE
22910 WEIGHTING_FACTOR_FOR_SCALE
22914 AXES_SCALE_ENABLE
22920 EXTERN_FEEDRATE_F1_F9_ACTIV
22930 EXTERN_PARALLEL_GEOAX
24004 CHBFRAME_POWERON_MASK
24006 CHSFRAME_RESET_MASK
28082 MM_SYSTEM_FRAME_MASK
182
Name
Number of digits for T number in the external
language mode
Tool change programming in external programming
language
External language is active in the control system
Assignment of geometry axis to channel axis
Geometry axis in channel
Machine axis number valid in channel
Name of channel axis in the channel
M number for changing over to the controlled spindle
mode (Siemens mode)
M number for changing over to the controlled spindle
mode (external language mode)
Reset G groups
Reset behavior of G groups
Definition of the G codes that are effective during
reboot, if the NC channel is not running in the
Siemens mode
Handling the tool length compensation G43/G44
Retract the tool length compensation
Interpolation behavior with G00
Function mask for external language
Default value of the FGROUP command
Specification of G groups that are output in the NCK
PLC interface, if an external NC language is active
Direction (inside/outside) in which the protection zone
is effective
Input resolution for scaling factor
Activation for axial scaling factor (G51)
Activation of fixed feedrate (F0 - F9)
Assignment of parallel channel geometry axis
Reset channel-specific basic frame after Power On
Active system frames after Reset
System frames (SRAM)
Programming Manual, 06/09, 6FC5398-7BP10-1BA0
ISO Milling