Siemens Sinumerik 840D sl Programming Manual page 157

10719
MD number
Default setting: 0
Changes effective after POWER ON
Data type: DWORD
Meaning:
10760
MD number
Default setting: 2
Changes effective after POWER ON
Data type: BYTE
Meaning:
10800
MD number
Default setting: -1
Changes effective after POWER ON
Data type: DWORD
Meaning:
MD cannot be changed for SINUMERIK 802D sl.
ISO Milling
Programming Manual, 06/09, 6FC5398-7BP10-1BA0
T_NO_FCT_CYCLE_MODE
Parameter assignment for T function replacement
min. input limit: -
This machine data is used to define, whether under simultaneous programming of D or DL
and T in a block D or DL is transferred as parameter to the T replacement cycle (default) or
it should be executed before calling the T replacement cycle.
Value 0: As earlier, the D or DL number is transferred to the cycle (default value) Value 1:
The D or DL number is calculated directly in the block
This function is active only if the tool change has been configured with M function (MD22550
$MC_TOOL_CHANGE_MODE = 1), otherwise the D or DL values are always transferred.
G53_TOOLCORR
Method of functioning with G53, G153 and SUPA
min. input limit: 2
This MD works in the Siemens mode and in the external language mode.
This machine data is used to define whether tool length- and tool radius compensations are
to be suppressed in the language commands G53, G153 and SUPA.
0 = G53/G153/SUPA is a non-modal suppression of work offsets, active tool length- and tool
radius compensation is retained.
1= G53/G153/SUPA is a non-modal suppression of work offsets and active tool length and
tool radius compensations.
EXTERN_CHAN_SYNC_M_NO_MIN
First M number for channel synchronization
min. input limit: 100
Smallest M number of the M range that is reserved for the channel synchronization.
Protection level: 2/7
Valid as of software version: 6.4
Protection level: 2/7
Valid as of software version: 5.2
Protection level: 2/7
Valid as of software version: 6.2
Data Description
C.1 General machine data
max. input limit: -
Unit: -
max. input limit: 4
Unit: -
max. input limit:
Unit: -
157